Setting Option Code; Exiting Service Mode; Resetting The Oven; Demo Mode - Thermador ME301J Series Service Manual

Service Manual for Thermador Masterpiece J-Series Built-in Wall Ovens

7.2.3 Setting Option Code

5. Locate the 4-digit code in Table 8 or on the label near the PC
control module in the upper plenum of the oven.
Note: Some MED272JS models built prior to June 2013 were
shipped with an option code label which incorrectly reflected
0941 as the option code. The correct option code is 1141.
6. Press to advance to the Option Code menu
FAST PREHEAT
selection.
7. Press , and enter / verify the 4-digit code .
START
8. To confirm the change after the code has been entered, press
to advance to the next menu item.
FAST PREHEAT

7.2.4 Exiting Service Mode

9. Press / to exit Service Mode.
ON OFF
10. Follow the instructions on the display to set the time and date.

7.2.5 Resetting the Oven

11. Unplug the unit or turn power off at the circuit breaker for 30
seconds.
12. Follow instructions on the display to set the time and date.
13. Confirm that the error code (if any) has been cleared, lights
are working properly, and oven is functioning normally.
8

DEMO MODE

The display and lights will work on 120VAC when the black and red
wires are tied together.
9

TROUBLESHOOTING

Use the Fault Tree Diagram and Fault Tree on the following pages to
guide troubleshooting efforts.
Copyright by BSH Home Appliances Corporation (Revised May 2013)
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
58300000170514 ARA EN B
1901 Main Street, Suite 600, Irvine CA
Page 24 of 37
800 444-9091