Table of Contents
Advertisement
BASIC OPERATION
Please refer to the text that appears under the switches when using the FCB8N unit in the basic
operation mode. On power up, the last selected PATCH will be loaded and transmitted (Initial value is
BANK#1, PATCH#1 in 12Pr mode).
BANK and PATCH Selection
Press the
BANK UP
or
BANK DOWN
BANK/PROGRAM
display will flash and no MIDI message will be transmitted until a PATCH is selected.
Hold the
BANK UP
or
BANK DOWN
BANK/PROGRAM
display will loop once it reaches BANK#32 if it is operating in 4Pr mode or BANK#10
if it is operating in 12Pr mode.
Select a PATCH by pressing the
4, ..., 12
switch if the unit is operating in 12Pr mode. The LED above the selected PATCH will illuminate
and the stored MIDI messages for that PATCH will be transmitted.
INSTANT ACCESS Control
Available only in 4Pr mode,
messages. The LED above the switch will illuminate to indicate the current status, on or off, of each
switch.
Each PATCH saves the state of all eight of the INSTANT ACCESS switches. When a PATCH is loaded the
state of each of the INSTANT ACCESS switches is recalled and transmitted.
INSTANT ACCESS states are saved to a PATCH by simply switching on or off the required states and
holding down the PATCH selection switch for 3 seconds.
When a change is made to the state of an INSTANT ACCESS switch for a PATCH, the LED above that
PATCH will flash (indicating that it has changed) until either the PATCH switch is pressed momentarily,
returning the PATCH to its original state, or the INSTANT ACCESS state is switched back to its original
state or the change is saved by holding down the PATCH switch for 3 seconds.
switch to move/scroll from the current BANK to another. The
switches on to scroll past the current BANK continuously. The
P1, P2, P3
or
P4
switch if the unit is operating in 4Pr mode or
C1, C2, C3, ...
to
C8
switches are used to send instant CC On/Off MIDI
PEAK FCB8N: Programmable MIDI foot controller
1, 2, 3,
Page 6 of 14
Advertisement
Table of Contents
