Table of Contents
Advertisement
E1.CH:
MIDI Channel for expression pedal messages.
Range: 01
E1.CC:
Control Change Numbers (CC#) for expression pedal Control Change Messages.
Range: 01
dAtA:
Data display for testing your expression pedal (Input signal checking). If your
expression pedal works with the FCB8N then the
show the pedal position value between 0
7. To save press the
FCB8N will return to operating mode.
Factory Restore
You can reset the FCB8N to the factory default settings. The data that you saved in the EEPROM memory
will be erased and the unit returned back the factory default settings.
There are two different numbering systems used by various MIDI equipment manufacturers, either 0
127 or 1
128, 0. The FCB8N can be configured to use either system (for example the POD2.0
uses 1
127, 0).
To restore the factory defaults:
1. Unplug the power from the FCB8N unit.
2. To restore to factory default settings to 12Pr mode:
-
Press and hold
-
Press and hold
3. To restore to factory default settings to 4Pr mode:
-
Press and hold
-
Press and hold
4. Plug the power into the FCB8N unit.
5. The
BANK/PROGRAM
restore.
6. When the
BANK/PROGRAM
release the switch.
7. Wait a moment until restore process has completed. The FCB8N will be initialized with the
factory default settings.
16
127
SAVE
switch or to exit without saving press the
P4
switch if you want to use 0
P3
switch if you want to use 1
P8
switch if you want to use 0
P7
switch if you want to use 1
display will show the characters below while it is processing a
display indicates that the unit has returned to operating mode,
PEAK FCB8N: Programmable MIDI foot controller
BANK/PROGRAM
127
CANCEL
127
127, 0
127
127, 0
display will
switch. The
Page 12 of 14
Advertisement
Table of Contents
