Brick Panels Installation; Levelling Legs - Mirage SERIES A Installation And Operating Instructions Manual

Brick Panels Installation

The panels for the firebox are shipped in a separate cardboard
box located inside the appliance. Carefully remove the panels
from the box and install them as follows:
1) Insert the right side panel into the firebox. Push the panel
completely to the rear so that it clears the window frame,
and then bring it forward slightly so that it tucks in behind
the window frame and allows room for the thickness of the
rear panel to come behind it.
2) Install the rear panel by tipping it back and into the space
between the baffle and the back of the firebox and so that
it sits on the ledge provided. Shift the rear panel tempo-
rarily to the right so that it tucks in behind the right side
panel, leaving room for the left panel to pass by it.
3) Similarly to installing the right panel, push the left panel
all the way to the rear to clear the window frame and then
pull it forward so that it tucks in behind the window frame.
f i r e - p a r t s . c o m
4) Center the rear panel and then adjust the side panels by
pushing them back against the rear panel.
Fig # 14
10

Levelling Legs

Levelling legs are provided with the appliance as a conven-
ient means for levelling the appliance when it is installed on
an irregular surface. The legs (3" long threaded bolts) are
supplied in a separate parts bag inside the appliance. Nuts
welded to the base, near the back of the appliance locate the
levelling legs. The legs thread into the nuts and protrude out
the bottom, raising the rear of the appliance until it is level
with the front.