For Your Safety Read Before Lighting; Lighting Instructions; To Turn Off Gas To Appliance - Mirage SERIES A Installation And Operating Instructions Manual

WARNING: If you do not follow these
instructions exactly, a fire or explosion
may result causing property damage,
personal injury or loss of life.
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
- Do not try to light any appliance.
- Do not touch any electric switch; do not use any
1. STOP! Read the safety information above on
this label.
2. Set wall thermostat to lowest setting, if applica-
ble.
3. Turn off all electric power to the appliance.
4. Open the bottom grill to access the controls.
5. Partially depress and turn gas control knob
clockwise
Note: Knob cannot be turned
f i r e - p a r t s . c o m
from "Pilot" to "Off" unless
knob is pushed in slightly.
Do not force.
6. Allow sufficient length of
time (minimum 5 minutes)
for any gas in the combustion chamber to
escape. If you still smell gas, STOP! Follow "B"
in the safety information above on this label. If
you don't smell gas, go to the next step.
7. Turn gas control knob back to "Pilot" position.
8. Depress gas control knob fully and hold while
1. Set wall thermostat to lowest setting, if applica-
ble.
2. Turn off all electric power to the appliance if
14

FOR YOUR SAFETY READ BEFORE LIGHTING

LIGHTING INSTRUCTIONS

past "Pilot" to "Off" position.
GAS KNOB

TO TURN OFF GAS TO APPLIANCE

phone in your building.
- Immediately call your gas supplier from a neigh-
bour's phone. Follow the gas supplier's instruc-
tions.
- If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in
or turn by hand, don't try to repair it, call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service techni-
cian to inspect the appliance & to replace any part
of the control system & any gas control which has
been under water.
you ignite pilot with the push button igniter. Once
the pilot ignites, continue depressing knob for
approximately 5 seconds (30 seconds if equipped
with a Robertshaw control valve). If pilot does not
stay lit, repeat steps 6 through 8, allowing a
longer period before releasing gas control dial.
- If gas control knob does not pop up when
released, stop and immediately call your service
technician or gas supplier.
- If the pilot will not stay lit after several tries, turn
the gas control knob to "Off" and call your
service technician or gas supplier.
9. Turn gas control knob counter-clockwise
"On" position.
10. Turn HI-LO burner control knob to desired
setting.
11. Close bottom grill and turn on the burner switch
12. Turn on all electric power to the appliance.
13. Set thermostat to desired setting, if applicable.
Note: Sufficient time must be allowed for air to
escape from lines if the unit is being lit for the
first time.
service is to be performed.
3. Push in gas control knob slightly and turn
clockwise to "Off". Do not force.
to