Table of Contents
Advertisement
7) Once positioned inside the firebox and
properly seated on the ledge, push the
burner assembly back and secure in
place with wing nuts provided. (Fig.
#12)
8) Fasten rear burner bracket to firebox
back with screws provided. (Fig. # 13)
9) Connect the wire harness from the
rocker switch to the control valve ter-
minal marked "TH" and "TH TP".
(Fig. #12) Feed the wire through the
smaller plastic bushing located next to
the gas inlet hole in the side casing.
(Fig. #11)
10)Place the self-adhesive label into the
blank box provided on the rating label
to designate the type of gas the appli-
ance is connected to.
f i r e - p a r t s . c o m
Fig # 12
Fig # 13
Wing Nut
9
Hide quick links:
Advertisement
Table of Contents
