Table of Contents
Advertisement
WLS8600
3 CONFIGURATION
3.1
CONFIGURATION METHODS
3.1.1
This manual can be used for complete setup and configuration of your reader by
following the setup procedures in this chapter (see par. 3.2 for an overview).
If you wish to change the default settings, this manual provides complete
configuration of your reader in an easy way.
To configure your reader:
1)
Open the folded page in Appendix C with the hex-numeric table and keep it
open during the device configuration.
2)
Read the Enter Configuration code ONCE, available at the top of each page
of configuration.
3)
Modify the desired parameters in one or more sections following the
procedures given for each group.
4)
Read the Exit and Save Configuration code ONCE, available at the top of
each page of configuration.
Reference notes describing the operation of the more complex parameters are given
in chapter 0.
3.1.2
A previously configured device (Master), can be used to send its configuration directly
to other devices of the same type (Slaves). The particular procedure for each device is
given in par. 4.11.
3.1.3
An alternative configuration method is provided in Appendix A using the RS-232
interface. This method is particularly useful when many devices need to be
configured with the same settings. Batch files containing the desired parameter
settings can be prepared to configure devices quickly and easily.
6
Reading Configuration Barcodes
Copy Command
Sending Configuration Strings from Host
Advertisement
Table of Contents
