Table of Contents
Advertisement
2
Read the code type from the Code Identifier Table beginning in Appendix
Read a number in the range 01-99 from the Hex/Numeric Table.
3
Since you can concatenate codes from different families, you must select the Code ID character
of the resulting code. The Code ID character will be sent in the output message only if it is
enabled according to the Code Identifier selection (Wasp, AIM, or Custom).
4
Define the timeout, which determines the valid waiting period between the two codes, in order to
accept concatenation. If the timeout expires, the resulting action will be based on the following
selection. (HHDII)
5
ADVANCED FORMATTING
Code 2
code ID
ÌEK1hÎ
code length
ÌEL1jÎ
Concatenation Result Code ID
use code 1 ID
ÌEN0kÎ
use code 2 ID
ÌEN1nÎ
Concatenation Timeout
timeout
ÌEJ3Î
Read two numbers in the range 00 to 99
00= no timeout
01-99 = timeout from 1 to 99 seconds
Transmission after Timeout
Exit and Save Configuration
Ì$-?Î
B
.
79
Advertisement
Table of Contents
