Operation Of Remote Controller - NEC NSC250F Owner's Manual

OPERATION OF REMOTE CONTROLLER

OPERATION DISPLAY
I t displays the current settings.
OPERATION
MODE button
Press it to select the operation mode.
COOL
AUTO
FAN DRY
TEMPERATURE
adjustment buttons
Press once, the setting
temperature increases by 1 .
Press once, the setting
temperature decreases by 1 .
The range of setting
temperature is 16-31 .
RUN/STOP button
Press it once to start operation
and press again to stop it.
FAN SPEED button
Press it to change the fan speed in
the order of low-medium -high-auto.
SLEEP button
Press it to start sleep running and
press again to stop it.
NOTICE:
Cool only type has no HEAT mode.
Keep the remote controller within 6 metres in front of the indoor unit without any blockage.
If the air conditioner is not used for a long time, take the batteries out.
In this illustration, each section is shown with all its displays ON for the purpose of
explanation. Some models may not show all its indications.
REMOTE CONTROLLER
Signal ejecting window
It sends signals to the indoor unit
HEAT
SWING
MANUAL
OPERATION
MODE
OFF
ON
TIME
SET
CANCEL
SLEEP
FAN SPEED
I/O
SWING button
Press it to change up/down air flow direction
and the deflector automatically swings up
and down.
MANUAL
SWING button
Press it to change up/down air flow direction
and the deflector moves at a certain angle.
you can change the moving angle in the order
of
(1) (2) (3)
ON TIMER button
Please see Timer operation
OFF TIMER button
Please see Timer operation
TIME SET button
Press it to fix the time setting.
TIME
CANCEL button
Press it to cancel the time setting.
RESET pieces
If the remote controller can't work
normally, short two RESET pieces
with forceps, it will be OK.
(4) (5)
8 8