Remote Control Features; Operation Mode Selection - NEC RSH2423S Owner's Manual

(1) A30045A(w fl+) 1994.10.12 12:36 PM '. 3 3 7
About the remote control on the system
The remote control transmits the signals to the system.
Features of the Remote Control- Door Opened
Heat pump model
Cooling model
OPERATION DISPLAY
1
Displays the operation conditions.
START/STOP BUTTON
2
Operation starts when this button is pressed
and stops when the button is pressed again.

OPERATION MODE SELECTION

3
BUTTON
Used to select the operation mode. (Refer to
page 8)
ON/OFF TIMER BUTTONS
4
Used to set the time of starting and stopping
operation.
TIME SETTING BUTTONS
5
Used to adjust the time.
TIMER SET/CANCEL BUTTONS
6
Used to set the timer when the desired time is
obtained and to cancel the Timer operation.
CHAOS SWING BUTTON
7
Used to stop or start louver movement and set
the desired up/down airflow direction.
3
4
5
6
7
Flip-up door(opened)
7
Signal transmitter
1
2
8
9
10
11
12
13
SLEEP MODE AUTO BUTTON
8
Used to set Sleep Mode Auto operation.
AIR CIRCULATION BUTTON
9
Used to circulate the room air without
cooling or heating (turns indoor fan on/off).
ROOM TEMPERATURE
10
CHECKING BUTTON
Used to check the room temperature.
NEGATIVE ION (Not on all models)
11
Used to generate negative ion.
HORIZONTAL AIRFLOW
12
DIRECTION CONTROL BUTTON
(Not on all models)
Used to set the desired horizontal airflow
direction.
RESET BUTTON
13
Used prior to resetting time or after
replacing batteries.