About the remote control on the system
The remote control transmits the signals to the system.
Features of the Remote Control- Door Open
Heat pump model
Cooling model
Flip-up door(opened)
OPERATION DISPLAY
1
Displays the operation conditions.
START/STOP BUTTON
2
Operation starts when this button is pressed
and stops when the button is pressed again.
OPERATION MODE SELECTION
3
BUTTON
Used to select the operation mode. (Refer to
page 8)
ON/OFF TIMER BUTTONS
4
Used to set the time of starting and stopping
operation.
TIME SETTING BUTTONS
5
Used to adjust the time.
TIMER SET/CANCEL BUTTONS
6
Used to set the timer when the desired time
is obtained and to cancel the Timer
operation.
CHAOS
ON
OFF
TIME
TIME
a.m.
a.m.
p.m.
p.m.
Hr.
3
ON
OFF
4
5
SET
CANCEL
6
7
RESET
AIRFLOW DIRECTION
7
START/STOP BUTTON
Used to stop or start louver movement and
set the desired up/down airflow direction.
SLEEP MODE AUTO BUTTON
8
Used to set Sleep Mode Auto operation.
AIR CIRCULATION BUTTON
9
Used to circulate the room air without
cooling or heating (turns indoor fan
on/off).
ROOM TEMPERATURE
10
CHECKING BUTTON
Used to check the room temperature.
RESET BUTTON
11
Used prior to resetting time or after
replacing batteries.
7
Signal transmitter
1
2
8
9
10
11