Replacing The Lamp - Nikon LS-4500AF User Manual

7. Replacing the Lamp

Note the following before replacing the lamp in case that the lamp is out of
order.
• Before replacing the lamp, turn off the power and unplug the power
cord.
• After the power cord has been unplugged, wait for approximately 15
minutes or more for the lamp to cool down.
• Use JCR 12V 20W/G1/A1.
• Never use a LS-3510AF lamp (12V 35W). It may cause damage to the
unit.
• Do not touch the bulb section of the lamp. Oil from your fingers will
shorten the life of the lamp.
The usual life of lamp used in the LS-4500AF is 2,000 hours. With normal
use, the lamp will need to be replaced approximately once every two years.
Step 1
Wait for about 15 minutes for the lamp to cool down after the power cord
has been unplugged, then open the cover on the top of the unit.
Nikon
Film Scanner LS-4500AF User's Manual
7. Replacing the Lamp
37