Nikon LS-4500AF User Manual page 53

When a mount is set in the tray for four frames, first slide the sliding spring
catch and carefully open the mount holding plate. The frame supports
itself in the upright position. If there is any mount for which scanning has
been completed, remove it.
Mount Holding
Plate
Put the mount on the mount plate after positioning it by means of the
slightly raised bars; close the mount holding plate carefully; fix the mount
holding plate firmly in place with the sliding spring catch. Make sure that
the emulsion side is facing downward.
Note: If there are fewer than four images to be scanned, add dummy films.
Proper scanning may not be performed if any transparent area is left.
Step 3
The arrow indicates the scanning direction. Rotate the turntable to set the
image angle.
For fine adjustment, refer to the angle index marked on the edge of the
turntable. The index may not match over the entire circumference.
Nikon
Film Scanner LS-4500AF User's Manual
6. Using the Film Holder
Sliding
Spring Catch
33