Overriding The Mini-Motorhome Slideout System - Jayco Mini-Motorhome Owner's Manual

Overriding The Mini-Motorhome Slideout System

The Power Gear slideout system is equipped with a manual crank override that allows
you to extend or retract the slideout if there is a loss of power.
If the system will not move when the switch is pressed, check the following:
• Is the battery connected?
• Does the battery have a full charge?
• Is the mini-motorhome master battery switch turned "ON"?
• Are the travel bars and tie down strap (if applicable) removed?
After checking the above, follow these steps to move the slideout manually:
1. Rotate the lever on the back side of the motor counter-clockwise about 1/8 turn
(Fig. 3-2). This will release the brake that locks the slideout in place.
2. Access the manual over ride located in front of the slideout rail assembly. Using a
3/4" or 1/2" drive with a 3/4" socket, crank slideout until fully retracted (or
extended).
3. When the slideout is fully retracted (or extended), apply pressure to the ratchet
handle and return the brake release lever to its normal downward position (Fig. 3-2).
This will ensure that the slideout is locked in a sealed position.
4. Install the travel bars and tie down strap (if applicable) and take the unit to a Jayco
dealer for service.
20
Fig. 3-1
Fig. 3-2