Chapter 4. Search Functions; Perms/Temps/Searching & Settings; Table 4.1. Settings Parameters For The Unity500; Table 4.2. Unity500 Settings Groups - Wegener unity 500 User Manual

Chapter 4. S
4.1. Perms/Temps/Searching & Settings
The term "
parameters:
Setting
The
Carrier
downlink frequency
absolute difference with the
Product Spec
Data_rate Data rate
Product Spec
The
Fec_rate
inner FEC code ratio
Product Spec
The
Tag_site
Carrier ID
downlink carrier frequency in MHz
control stream and the selected value must correspond to the
received.
Note:
This is the
[program]
stream. It must be a
wildcard is entered, the unit will select the first available program in a program table
contained with the Transport stream.
The IRD is acting on one of three groups of settings at any given time, each of which is
described in
Settings Group
These settings are entered via
Temp
unit is said to be inserting when it is configured to the temp settings. The maximum length
of an insert is approximately 18 hours (65535 seconds). An insert terminates when
1. It times out,
2. An
Any Temp commands received while the receiver is currently inserting are ignored. If a
Perm command is received while inserting, the perm settings are updated but not acted
on until the insert is terminated.
The perm settings are entered via
Perm
Select
settings are the only settings group that are stored in NVRAM.
The search settings are active while in
Search
unit finds what it is looking for in the search mode, it copies the search settings to the
perm settings. These are then considered to be the active settings. See
Settings Table (or Search Table)
www.wegener.com
EARCH
" is used throughout this document and includes the following set of
settings

Table 4.1. Settings Parameters for the UNITY500

specified in MHz with up to two decimal places. This value's
LNB LO
.
is specified in Mbps with up to three decimal places. See the main body of the
for the allowable range.
can have one of the values specified in the main body of
.
" " with a value range of
tag
Tag site is a special entry. It means "
15
".
matching carrier ID
, the identifier for a Program within the received Transport
Program number
wildcard or a number between
*
:
Table 4.2

Table 4.2. UNITY500 Settings Groups

COMPEL
command is received,
ABORT
screen, or automatically from within a search mode. (See below.) The perm
F
UNCTIONS
Description
frequency must be as specified in main body of the
through . The
0 15
. For multi-hop links, multiple tags are embedded in the
receive this carrier without requiring a
and
1
Description
or the
TEMP / TEMPCH
3. Power is cycled, or
4. An invalid header is seen.
, the
COMPEL PERM / PERMCH
or
Carrier Search Header Search
below.
23
U 500 U ' M
NITY SER S ANUAL
is text representing the
tag
downlink being
particular
inclusive. If the
*
65535
terminal commands. The
terminal, or
OSD Carrier
modes. When the
Section 4.2,
800001-01 Rev. E