Power-On Procedure; On-Screen Network E-Mail; On-Screen Display (Osd) - Wegener unity 500 User Manual

3.4. Power-On Procedure

Apply power to the IRD. The unit initializes various devices and configures itself
according to the
power up test, which takes about 10 seconds.
When the receiver section passes its test, the IRD sends a tune command and the
Welcome Banner
the unit is in
enters
Figure 3.2: Unity 500 Terminal Welcome Banner Screen
Your banner may be different from this example depending on the options purchased.
NOTE:

3.5. On-Screen Network E-mail

The network may, through the
the video (OSD) screen. The content, location, and duration of the messages are
essentially under the control of the network. The local user may neither move nor scroll
through the messages. If necessary, a message may be cleared by the local user by:
1. Either power-cycling the unit,
2. Or pressing the
[See Section

3.6. On-Screen Display (OSD)

The OSD information is contained in a 14-line x 40-character display in the video output
from the receiver. This output is viewed on a monitor connected to the video monitor
output of the receiver. Turn it on by pressing either the
the front panel. Remove the display by selecting
menu is first shown, the cursor is always placed on its first
field, whichever is first).
The OSD provides the following:
1. Carrier Status,
2. Signal Strength Monitoring,
3. Serial Port device selection,
www.wegener.com
settings. It then waits for the receiver section to complete its
EEPROM
screen to the serial port.(An example is shown in
mode, the banner displays on the terminal screen. The IRD then
Terminal
mode until all of the alarm conditions are cleared.
Alarm
Wegener Communications Copyright 2000
Unity 500 Integrated Receiver Decoder
Application : V106
Boot : V102
Xilinx : CA600048-01 100
Secure : 600041 1.1
Tuner : L64724D
Type H for a list of terminal commands
The " " text at the bottom of the screen is shown only if the serial device
Type H...
is set to mode.
Terminal
COMPEL
SELECT
then exiting out of that menu.
3.7.2 On-Screen Display (OSD) Settings
network control system, send e-mail messages to
button on the front panel to get a local control menu and
on page 21.]
SELECT
from the
EXIT
13
U 500 U ' M
NITY SER S ANUAL
below.) If
Figure 3.2
or push-button on
ENTER
. When a
Main Menu
field (or
action action-with-edit
800001-01 Rev. E