Basic Function; Troubleshooting; Wiring Diagram - Planet Audio P9640B User Manual

BASIC FUNCTION

1. / SRC button
If unit is off:
Press this button to power on the unit.
If unit is on:
Long press this button to power off
Short press to cycle thru modes.
2. IR
To receive infrared signal from the remote control.
3. EQ button
In a source mode, press the button to enter equalizer setup.
4. MENU button
Press this button to back to the main menu.
5. VOL button
Rotate the button to adjust volume level
6. SD
Insert SD card, the unit will play the files automatically.
7. Dual (front and rear) USB
Insert USB removable device so as to read audio/video files.
Warning: You can only use either front or rear USB at a time. Never connect both
front and rear USB at the same time! This could cause malfunctions.
8. AUX
To input external audio.
9. RESET
Press this button and this unit will be restored to the initial state.
10.
At radio state, short press this button to manual seek radio frequency to backward
direction; long press this button to automatically seek radio frequency to backward
direction; At voice playing state, short press this button to select the previous song;
In the playback, press rewind function can be realized.
11.
At radio state, short press this button to manual seek radio frequency to backward
direction; long press this button to automatically seek radio frequency to backward
direction; At voice playing state, short press this button to select the next song;
In the playback, press fast forward function can be realized.
.
03
This player is equipped with ISO standard connector, please follow below instruction:
Red - ACC ON (+12V) (+)
●
Yellow – 12 V Constant (+)
●
Black – Ground wire (-)
●
Blue - Power Antenna / Remote Amp Turn On (+)
●
Violet/White-Reverse Gear Signal (+)
●
E
C
A B
V-OUT1 R L R R
V-OUT2 C A M SW
V-IN AUX-L AUX-R
G3 G2 G1
5
G6 G5 G4
D F
ANT
G9 G8 G7
E
ANT-FM/AM antenna
G1 - Red Rear RCA R output
E1-Black Learning SWC GND
G2 - White Rear RCA L output
E2-Brown Learning SWC
G3 - Yellow VIDEO–OUT1
E3- White Learning SWC
G4 - Brown Subwoofer output
E4-Dark grey with Red /White tip
G5 - Yellow Rear view input
Front RCA output (Right Red
G6 - Yellow VIDEO –OUT2
Left White)
G7 - Red AUX R Audio input
E5-Brown Subwoofer output
G8 - White AUX L Audio input
E6-Rear USB Plug
G9 - Yellow Video input
E7-BT MIC
TROUBLE SHOOTING
PROBLEM CAUSE
Check fuse
Cannot power on
Some factors cause MPU
wrong operation
After ignition switch
Change battery or fuse
off, setting
information all lose
Poor performance
Weak signal
of radio station
Cannot load disk There is a disk inside
Disc is scratched
Put wrong side of disc into
Cannot play disc
the unit
Lens is dirty
Cannot switch
There is only one language/
language/subtitle
subtitle in disc
Other factors cause MPU
No image
wrong operation
Cannot watch
It's not allowed to watch image
image during
during driving
driving

WIRING DIAGRAM

Grey/Grey black - Right front speaker (+/-)
●
White/White black - Left front speaker (+/-)
●
Purple/Purple black - Right rear speaker (+/-)
●
Green/Green black - Left rear speaker (+/-)
●
Light Green-Parking Brake
●
1 3 5 7 9 1113 15
F
2 4 6 8 10 12 14 16
5
1.Black ---GND battery(–)
2.Yellow --- BATT battery(+)
3.Red --- ACC switch control(+)
4.Light Green --- Parking Brake
5.NC
6.Violet/White --- Reverse Gear Signal(+)
7.Blue --- ANT Radio automatic antenna(+)
8.NC
9.Purple --- right rear speaker (+)
10.Purple/black --- right rear speaker(–)
11.Grey --- right front speaker (+)
12. Grey/black --- right front speaker (–)
13.White --- left front speaker (+)
14.White/black --- left front speaker (–)
15.Green --- left rear speaker (+)
16. Green/black --- left rear speaker (–)
SOLUTION
Change fuse same as the old one
Press RES button on the panel by penpoint,
then, power on
Reset information and save
Move the car to another place, then research
Remove disc before inserting another one
Change new disc
Insert in the disk with sign side up
Clean lens by lens clean disc
If disc is not with multi-language/subtitle, it
cannot switch language/subtitle
Press RES button on the panel by penpoint,
then, power on
Park the car in a safe place, put the car stall
in " P " postion, pull up the hand brake,
parking brake wire must be grounded
16