Table of Contents
Advertisement
Common Problems
Having this problem
No Picture
(Power LED not lit)
No Picture
(Power LED is amber or yellow)
Screen
Screen says
Imaging Problems
Display position is incorrect
Image vibrates on the screen
Vertical flicker appears
Horizontal flicker appears
The screen is too bright or too dark
Trouble shooting
Check these items
·
Make sure the power cord is plugged into the power outlet
and into the back of the monitor.
·
First, ensure that the power button on the front of the monitor
is in the OFF position, then press it to the ON position.
·
Make sure the computer is turned on.
·
Make sure the signal cable is properly connected to your
computer.
·
Check to see if the monitor cable has bent pins.
·
Make sure the monitor cable is properly connected to your
computer. (Also refer to the Quick Set-Up Guide).
·
Check to see if the monitor cable has bent pins.
·
Make sure the computer is turned on.
·
Make sure the vertical sync of input signal is within the range
of 56 ~ 75 Hz.
·
Change the refresh rate to 56~75Hz within 10 minutes.
·
Re-power on monitor to start over again if you failed to
change the refresh rate within 10 minutes.
·
Press the Auto button.
·
Adjust the image position using the Horizontal Position and/or Vertical
Position in OSD Main Controls.
Check that the signal cable is properly connected to the graphics board or PC.
·
Press the Auto button.
·
Eliminate the vertical bars using the More Settings of Phase/Clock in
OSD Main Controls.
·
Press the Auto button.
·
Eliminate the vertical bars using the More Settings of Phase/Clock in
OSD Main Controls.
·
Adjust the contrast and brightness on OSD Main Controls. (The
backlight of the LCD monitor has a fixed life span. When the screen
becomes dark or begins to flicker, please contact your dealer).
17
190P6&170P6 LCD
Go to cover page
Hide quick links:
Advertisement
Table of Contents
