Haier DWL3025 Installation Manual page 15

11c. WASTE DISPOSER - WITH NO AIR GAP
1. Remove the disposer knockout plug.
Do not cut end of drain hose.
2. Attach drain hose "I" to disposer inlet "N" with large
spring-type clamp "K".
This connecting "N" MUST be made before drain trap
installed.
3. The drain hose must be looped up and securely fastened
to the underside of the counter before going to the drain.
11d. NO WASTE DISPOSER - WITH NO AIR GAP
clamp* "M". The connection "P" MUST be made before drain trap "O" and
3. The drain hose must be looped up and securely fastened to the underside
of the counter before going to the drain. Hose loop must be a minimum 30
To reduce the vibration of the hose, keep the hose away from the
floor and the edge of the hole where it passes through the cabinet.
* Parts available from local plumbing supply stores.
Insert drain hose "I" into hole cut in cabinet and guide
toward the back center of opening where drain connection
will be made.
HELPFUL TIP:
English
14