Haier DWL3025 Installation Manual page 13

Wiring the dishwasher will be easier if you route wire
into the cabinet opening from the left side.
3. DIRECT WIRE METHOD:
Cut a 3/4
rear or floor. Optional locations are shown. Wood
Cabinet: Sand hole until smooth.
3a. POWER SUPPLY CORD METHOD:
Cut a 11/2
or side. Optional locations are shown. Wood cabinet:Sand hole until smooth.
4.
4a.
Install a mating, three-prong, grounding-
dishwasher opening. Go to step 6.
5.
Run other end of wire through cabinet hole.
opening. Go to step 6.
Install a mating, three-prong, grounding-type wall
opening. Go to step 6.
WATER LINE
Routing the water line through the left side of
cabinet opening will make water connection easier.
6.
cabinet side,rear or floor. Optional locations are shown.
hole "D")
7.
Measure total length of copper tubing "G" required.
Attach copper tubing to water line with manual shut-
off valve. Carefully feed copper tubing through hole in
it is far enough into the cabinet opening to connect it to
dishwasher inlet on the front left of dishwasher.
HELPFUL TIP:
strain relief method provided
HELPFUL TIP:
English
E
12