How To Use A Preset Workout - Pro-Form XP 185 U User Manual

HOW TO USE A PRESET WORKOUT
1. Turn on the console.
To turn on the console, press any button or begin
pedaling. The display will light and the console will
be ready for use.
2. Select a preset workout.
To select a preset
workout, press the
Workout button repeat-
edly until the number
of the desired workout
appears in the display.
I ,=J LJ'&,J LJ
TIME
9
The first section of the display will show how long
the workout will last. A profile of the resistance lev-
els for the workout will scroll across the last sec-
tion of the display. Note: Complete profiles of the
preset workouts are printed on the sides of the
console.
3. Press the Start button or begin pedaling to
start the workout.
Each workout is divided into 30 one-minute seg-
ments. One resistance level and one pace setting
are programmed for each segment. Note: The
same resistance level and/or pace setting may be
programmed for consecutive segments.
During the workout, the workout profile will show
your progress. The flashing segment of the profile
represents the current segment of the workout.
The height of the flashing segment indicates the
resistance level for the current segment. At the
end of each segment of the workout, a series of
tones will sound and the next segment of the pro-
file will begin to flash. If a different resistance level
is programmed for the next segment, the resis-
tance level will flash in the center display for a few
seconds to alert you. The resistance of the pedals
will then change.
As you exercise, the
display will prompt you
to keep your pedaling
pace near the pace
setting for the current
segment. When the
MPH
word "faster" appears in the display, increase your
pace. When the word "slower" appears, decrease
your pace. When the center of the target flashes,
maintain your current pace.
IMPORTANT: The pace settings are intended
only to provide motivation. Your actual pace
may be slower than the pace settings. Make
sure to pedal at a pace that is comfortable for
you.
If the resistance level for the current segment is
too high or too low, you can manually override the
level by turning the Resistance dial. IMPORTANT:
When the current segment of the workout
ends, the pedals will automatically adjust to
the resistance setting for the next segment.
If you stop pedaling for several seconds, the time
will begin to flash in the display. To restart the
workout, press the Start button or simply resume
pedaling.
The workout will continue until the display shows a
time of 0:00. If you continue to pedal after the
workout is completed, the display will continue to
show exercise feedback; however, the display will
not show the elapsed time until you select the
manual mode or a new workout.
4. Follow your progress with the display.
See step 4 on page 13.
5. Measure your heart rate if desired.
.
See step 5 on page 14.
When you are finished exercising, the console
will turn off automatically.
See step 6 on page 14.
15