Determine Cabinet Opening - Whirlpool GU2800XTV Manual

5
Power Cord—Reinstall
terminal box cover
Place wires inside terminal box. Insert tabs on
left side of cover. Make sure wires are tucked
inside box. Close cover ensuring wires are not
pinched. Use 1/4" nut driver and previously
removed screw to secure cover.
NOTE: Do not plug into outlet until instructed.

Determine Cabinet Opening

1
Measure cabinet opening
Measure height of cabinet opening from under-
side of countertop to floor where dishwasher
will be installed (you will need to measure the
lowest point on the underside of the countertop
and the highest point on the floor). Refer to
"Dishwasher Height Adjustment Chart" for wheel
position and the number of turns needed.
Dishwasher Height Adjustment Chart
Cabinet
opening height
33-7/8" (86.0 cm)
34" (86.4 cm)
34-1/4" (87 cm)
34-1/2" (87.6 cm)
NOTE: If the minimum cabinet opening height
is less than 34"(86.4 cm), the rear wheels can
be removed for additional clearance. This will
allow the dishwasher to fit into a 33-7/8" (86
cm) high cabinet opening, but the dishwasher
will be more difficult to move. (Measurements
are approximate. Wheels and legs are preset
at the factory for 34-1/2" (87.6" cm).)
2
Adjust wheels and legs
Turn both leveler legs to the same height. Put
wheels in the required position determined
from "Dishwasher Height Adjustment Chart".
(To change wheel position, use a flat bladed
screwdriver to pop out the wheel, then snap
into the new position.)
2-16
Wheel Number of turns
position on front leg
Removed All the way up
1 10
2 5
3 0
3
2
1