Whirlpool GU2800XTV Manual page 12

Gather the required tools and parts before start-
ing installation. Read and follow the instructions
provided with any tools listed here.
TOOLS NEEDED
• Pliers
• Phillips screwdriver
• Flat-blade screwdriver
• 5/16" and 1/4" nut drivers or hex sockets
• Measuring tape or ruler
• UL listed or CSA approved twist-on wire
connectors *
• 10" adjustable wrench that opens to 1-1.8"
(2.9 cm)
• Utility knife
• Small Level
• 5/8" open-end wrench
*Must be the proper size to connect your house-
hold wiring to 16-gauge wiring in dishwasher.
Other useful items you may need:
Flashlight
Shallow pan
PARTS SUPPLIED
2 - Drain hose clamps
(1 large and 1 small)
Green
Silver
Make sure all these parts are included in the literature package.
Make sure all these parts are included in the
literature package.
Bath towel
Wood block
2 - #10 x 1/2"
Drain hose
Phillips-head
screws
PARTS NEEDED
Other parts you may also need:
1-1/2"–2"
(38.1– 5.0 cm)
Screw-type
clamps (3 max)
NOTE: Parts available for purchase in plumb-
ing supply stores. Check local codes. Check
existing electrical supply. See "Electrical Re-
quirements" section. It is recommended that
electrical connections be made by a licensed
electrical installer.
In addition, for first time installations
Tools needed:
Electric drill
with 1/2", 3/4"
and 1-1/2" hole
saw bits
Parts needed:
Copper tubing (3/8"
O.D. suggested) or
flexible braided
water supply line
® Teflon is a registered trademark of E.I. Du Pont de
Nemours and Company.
2-2
Side mounting kit
Masking or
for solid surface duct tape
countertops
(Part No. 8212560)
Small
Wire stripper
tubing cutter
See "Electrical Requirements" section
For Direct Wire: For Power Supply
use UL listed or Cord: use UL
CSA approved listed power
conduit supply cord kit
connector to marked for use
fit 7/8" (2.2 cm) with dishwasher
hole