Whirlpool GU2800XTV Manual page 22

Option C, Waste disposer – with air gap
Waste disposer – with air gap
Screw-type clamps Screw-type clamps
Disposer inlet
1.
1
2.
2
3.
3
Black end
4
4.
5
5.
Air gap
Large silver drain
hose clamp
Rubber hose
connector
Drain hose
Drain trap
Using a hammer and
screwdriver, knock plug
into disposer.
Use needle nose pliers
to remove plug.
Connect black end of
drain hose to air gap
and cut if needed.
(Do not cut ribbed
section.)
Attach drain hose to
air gap with large sil-
ver drain hose clamp
(provided). Use pliers
to squeeze clamp
open and move into
position. If the drain
hose was cut, use a
1-1/2" to 2"(3.8 to 5
cm) screw-type clamp
(not provided).
Use a rubber hose
(not provided) with
screw-type clamps
(not provided) to
connect from air gap
to disposer inlet.
Option D, No waste disposer – with air gap
No waste disposer – with air gap
Screw-type clamps Screw-type clamps
Waste tee
1
Black end
2
3
2-12
Air gap
Large silver drain
hose clamp
Rubber hose
connector
Drain hose
Drain trap
1. Connect black end of
drain hose to air gap
and cut if needed.
(Do not cut ribbed
section.)
2. Attach drain hose to
air gap with large sil-
ver drain hose clamp
(provided) Use pliers
to squeeze clamp
open and move into
position. If the drain
hose was cut, use
a 1-1/2" to 2"(3.8 to
5 cm) screw-type
clamp (not provided).
3. Use a rubber hose
(not provided) with
screw-type clamps
(not provided) to con-
nect from waste tee
to air gap.