Color Settings - Epson powerlite home cinema 3010+ User Manual

■ Noise Reduction
Signal > Advanced > Noise Reduction
Note: This setting may not be available when the Color Mode is set to Auto (see page 30) or
with a signal input through the PC port.
This setting reduces flickering of analog images. You can select from 3 levels of noise
reduction.
■ 2-2 Pull-down
Signal > Advanced > 2-2 Pull-down
Note: This setting can be used only when viewing a 1080p/24Hz signal input through the
Component, HDMI 1, or HDMI 2 ports (see page 74). This setting cannot be used when the
Color Mode is set to Auto (see page 30) or with a signal input through the PC port.
This setting allows you to select whether images are projected with 2-2 Pull-down
detection or 2-3 Pull-down detection. Select

Color Settings

If the image colors don't look correct, you can adjust them using these settings. Use the first
three settings described below to make the most visible changes. If you only need to make
slight adjustments, you can fine-tune the picture with the remaining settings. Most color
settings are stored separately for each image source and color mode.
■ Color Saturation
Image > Color Saturation
Note: This setting cannot be used when the Color Mode is set to Auto (see page 30) or with a
signal input through the PC port.
Adjusts the color intensity of the image.
■ Tint
Image > Tint
Note: This setting cannot be used when the Color Mode is set to Auto (see page 30) or with a
signal input through the PC port.
Shifts the color balance between magenta and green.
40
Making Detailed Adjustments
for 2-2 Pull-down detection.
On