Epson powerlite home cinema 3010+ User Manual page 17

Port name Video equipment connection
Video Use an RCA video and audio cable:
For best results, connect your video equipment to the
equipment doesn't support HDMI, connect it to either the
component video) or
When you connect an HDMI cable to the projector, it is recommended that you fasten it
with the included cable clip. Follow these steps to install the cable clip:
1. Connect the HDMI cable to one of the
2. Insert the guide of the cable clip into the cable clip hole near the HDMI port, as show
below.
3. Place the open cable clip around the HDMI cable, but don't lock it into place.
4. Slide the cable clip towards the projector and lock the clip onto the HDMI connector.
To remove the cable clip, unlock the clip and disconnect the HDMI cable. Then pinch the
side of the guide of the cable clip and carefully pull it out of the cable clip hole.
(for composite video) port.
Video
Computer connection
—
port, if possible. If your
HDMI
Component
ports on the projector.
HDMI
(for high quality,
Setting Up the Projector
17