Fitting The Microphone; Fitting The Radio - GME TX3600 Series Instruction Manual

Fitting MC522BC Microphone
Screw the LCD Controller Microphone and the clip to a
firm surface. Position the LCD Controller Microphone in its
mounting clip. Finally, plug the LCD Controller Microphone
into the front panel. An additional 1.8 m extension cable is
supplied to allow more remote mounting of the main unit.
Slide Microphone
into the mounting clip

Fitting the Radio

Slide radio fully into cradle until it clicks into place.
Removing the Radio
Gently
spread
tabs
Slide Radio
from cradle
T X 3 6 0 0 S ERI ES

Fitting the Microphone

The microphone uses a miniature 6 pin telephone style plug
and socket. To fit the microphone:
1. Position the microphone plug so the plastic tab faces
2. Gently press the rubber strain relief into the hole
MC522BC
removing the microphone
1. Squeeze the rubber strain relief near the front panel to
2. Squeeze the plastic tab on the microphone plug towards
Console Mounting the TX3600 Series
For console mounting, a flush mounting DIN Adaptor
MBD001 is available as an optional accessory. The adaptor
includes mounting brackets and a specially designed
front panel escutcheon to suit most vehicle installations.
Installation instructions are provided with the bracket.
See your nearest GME retailer for details.
din adaptor MBd001
Gently
spread
tabs
INSTRUCTION M ANUAL
downwards. Press the plug into the socket until
it 'clicks'.
surrounding the socket so that the slot around the strain
relief fits neatly inside the lip of the hole.
Fitting Mic to
front panel
disengage the slot, and slide the strain relief back along
the microphone cord.
the plug to unlock it while gently pulling the plug
outwards. If the plug does not come out easily, the tab
has not released correctly and should be squeezed again.
Fitting MC522BC
to TX3600 Series
PAGE 21