Ctcss/Dcs; Installation - GME TX3600 Series Instruction Manual

With the PAGE mode selected, the radio will operate
normally and you can transmit and receive on the selected
channel.
• If the selected channel has been tagged for Quiet
operation, the QUIET mode will be automatically selected
and 'QUIET' will be displayed. In this case, you will not be
able to transmit.
• If your Selcall Ident is received, your TX3600 Series
will send an acknowledge beep back to the caller then
change to the Paging channel and transmit the Page
Ident. It will finally return to the selected channel, sound
the alarm and display the Ident or Name of the caller.
Scanning in the PAGE Mode
To Scan in the Page mode, simply select the required scan
group, program the required channels, then briefly press the
SCAN key. The radio will begin scanning.
Now select the PAGE mode by holding the CaLL key and
pressing the Channel Selector knob.
MC522BC- Now select the PAGE mode by holding the CaLL
key and pressing the A key.
To return a Call in the PaGE Mode
If you return to your radio and it is beeping, briefly press the
Channel Selector knob. The radio will exit the PAgE mode
and 'CALL FroM' will be displayed along with the Ident or
Name of the caller.
MC522BC- If you return to your radio and it is beeping,
briefly press the A key. The radio will exit the PAgE mode
and 'CALL FroM' will be displayed along with the Ident or
Name of the caller.
Briefly press the CaLL key. 'CALL To' will be displayed along
with the Ident or Name of the caller. Now press and hold the
CaLL key for a few seconds until the radio beeps. The callers
Selcall Ident will be sent. If the call is successful, you will
hear two quick acknowledge beeps in your radio's speaker
as the caller's radio responds.

CTCSS/DCS

CTCSS (Continuous Tone Coded Squelch System) and DCS
(Digitally Coded Squelch) is a quieting system that allows
a group of radios to talk to each other without hearing
other users on the channel. The system applies a continuous
low level tone to your transmission, and a matching tone
decoder to your receiver's Squelch. When CTCSS/DCS is
enabled the channel remains quiet until someone transmits
using the same tone. When the transmission ends, the
channel becomes quiet again. By using different tones,
several groups of people can share the same channel
without disturbing each other.
If CTCSS/DCS has been enabled by your retailer, it will have
been preset on specific channels.
PAGE 2 0
The TX3600 Series is supplied with a slim, slide-on
mounting cradle. The cradle can be screwed or bolted in any
convenient location in your vehicle (under or above the dash,
on the centre console, etc) using the mounting slots provided
in the base. The TX3600 Series contains a built-in speaker
and can be installed with the speaker facing upwards or
downwards to ensure the receiver audio is projected clearly.
Alternatively, the TX3600 Series can be fitted with an
extension speaker if required.
When installing the radio, avoid mounting it close to heaters
or air conditioners. Screw the mounting cradle to a firm
surface. Slide the TX3600 Series into the cradle from the
front until it clicks into place. Finally, plug the power and
antenna leads to the sockets provided on the rear of the
radio.
Fitting RH003 Remote Head
Mounting the Cradle
INSTRUCTION M ANUAL

INSTALLATION

T X3600 S ER IES