Select Hoop - Pfaff Creative Sensation Pro II Owner's Manual

Common
pop-ups
When the embroidery unit is attached, a pop-up
asks you to slide off the hoop and clear the machine
area for calibrating the embroidery arm. You will
also be reminded to disengage the IDT system and
™
attach the Dynamic spring foot 6D for embroidery.
Note: It is very important to remove the hoop, otherwise
the hoop or the embroidery unit may be damaged while
calibrating.
Attach correct hoop
If the size of the hoop attached to the machine does
not match the size displayed on screen, the machine
will not embroider. You must change the hoop to
the displayed size or change the hoop setting to the
hoop size attached.
To change hoop settings, re-enter Embroidery edit
and go to select hoop.
When the bobbin thread is running low, a pop-up
message appears giving you an indication that the
bobbin needs to be changed soon. This gives you
an opportunity to plan where to stop embroidering
and change the bobbin.
It is possible to embroider until the thread
completely runs out. Press Start/Stop button to
continue embroidering, without closing the bobbin
thread low pop-up.
Touch cancel to remain at the current stitch position.
4
Touch OK to move the hoop to bobbin position.
The hoop position tab opens. Replace the empty
bobbin with a full one. Touch Current position and
pull back excess needle thread. Move a few stitches
backwards using the current stitch icons (4). Press
start/stop or press your foot control to continue
embroidering.
9:13