Pfaff Creative Sensation Pro II Owner's Manual page 98

Remove the
1. To store the embroidery unit in the embroidery
case, move the embroidery arm to park position
by selecting park position on the screen in either
Embroidery edit or Embroidery stitch-out.
2. Press the button at the left, underneath the
embroidery unit (A) and slide the unit to the left
to remove it.
3. The cover of the socket closes automatically.
4. Store the embroidery unit in the original
packing material, place in the soft carrying bag.
1. Disengage the IDT
™
standard presser foot (B). Carefully loosen the
screw (C) until the cross-hole (D) is accessible.
2. Hold the foot in front of the needle. Turn the
hand wheel to lower the needle into the hole of
the foot and through the needle plate.
3. Turn the foot behind the needle screw (E) and
insert the pin of the foot into the cross-hole (D)
of the presser foot holder.
4. Push the foot into the hole as far as it will go
while tightening the screw (C).
To remove the embroidery foot loosen the screw
(C), squeeze the embroidery foot together and pull
it out to the right. Tighten the screw.
7:4
system (A). Remove the
A
1
C
A
2
4
C
D
B
3
E