Hoop Position - Pfaff Creative Sensation Pro II Owner's Manual

Use the hoop position functions to move the hoop to
different positions.
Current position
When you want to return to the current stitch and
11
start embroidering again where the embroidery was
interrupted, touch the current position icon. You can also
press the start/stop button once to return to the current
stitch and start to embroider.
Park position
hoop and select park position. The embroidery arm will
be placed in a position that will allow easy storage.
Use the park position when you need to have a free
sewing space with the embroidery arm out of the way.
Note: It is very important that the hoop is removed, otherwise
it may be damaged.
Bobbin position
To make it easier to change the bobbin, touch bobbin
position. The hoop will move backwards, allowing you
to open the bobbin cover and replace the bobbin.
Cut position
Cut position will move the hoop towards you making
it easier to cut jump stitches and trim fabric when
embroidering an appliqué.
Center position
Use the center position if you want to check where the
center position of the hoop will be placed on the fabric.
12
This function enables you to easily reduce the maximum
embroidery speed. Just touch the speed control icon to
reduce the speed. To return to normal speed, deselect the
icon.
You can change the set speed limit. Long touch the speed
control icon to get a pop-up. Set desired speed limit
using the slider then close the pop-up. The next time you
touch the speed control icon, the speed will be reduced
to the limit you have chosen.
You can embroider without closing the pop-up.
Note: You cannot set maximum speed in the popup. To set
maximum speed, close the popup and deselect the speed icon.
9:7