Maintenance; Troubleshooting - Rowi HWK 2000/3/2 Basic Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

P Always clean the appliance while cool.
P Pull out mains plug before any work.
P Only clean the appliance with a dry, soft cloth. Never use sharp and/or abrasive
cleaning agents.
4.3

Maintenance

Note that only original parts may be used for repair and maintenance work. Contact the
ROWI Service Centre if need be (see Chapter 5).
4.4

Troubleshooting

Fault
The appliance does
not start.
The appliance switches
off during operation.
The blower function
does not function.
Tab. 5: Error diagnosis
*depending on model
Possible cause(s)
No power or voltage too
low.
The appliance is not
switched on.
The room temperature is
above the temperature set at
the thermostat.
The thermal protection switch
has triggered. The appliance
has exceeded the maximum
permissible temperature.
The room temperature is
above the temperature set at
the thermostat.
The blower function* is not
switched on.
31/40
Remedy
Make sure the plug is plugged
into the socket. Check the
power supply voltage.
Move the heating level switch
to position "I" or "II".
Increase the
thermostat temperature.
Switch the appliance off, by
moving the heating level switch
to position "0" and pull the
power plug out of the socket.
Allow the appliance to cool
down for several minutes.
Check the air inlet and air
outlet openings and remedy
the cause of the overheating
before restarting the appliance.
Increase the
thermostat temperature.
Switch the rocker switch to
position "I"
GB

Advertisement

Chapters

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HWK 2000/3/2 Basic and is the answer not in the manual?

This manual is also suitable for:

Hwk 2000/3/2 g basic

Table of Contents