Inserting And Removing The On-Board Computer; Switching On/Shutting Down The On-Board Computer - Bosch Nyon Operating Instructions Manual

English – 17

Inserting and removing the on-board computer

To insert the on-board computer 3, slide it from the front into the holder 4.
To remove the on-board computer 3, press the lock latch 17 and slide the
on-board computer toward the front out of the holder 4.
 Remove the on-board computer when you park the eBike.
It is possible to secure the on-board computer against removal in the
holder. To do so, remove the holder 4 from the handlebar. Put the on-
board computer in the holder. Screw the locking screw 18 (thread M3,
8 mm long) from below into the thread provided in the holder. Mount the
holder back onto the handlebar.

Switching on/shutting down the on-board computer

To switch on the on-board computer briefly press the On/Off button 5.
To shut down the on-board computer press the On/Off button 5 for at least
1 second.
If no button is pressed after 5 minutes, Nyon goes into power saving mode
(back lighting off) and shuts down automatically after a further 5 minutes.
Bosch eBike Systems 1 270 020 Wen | (13.5.16)