Power Supply Of External Devices Via Usb Connection; Initial Operation Of The On-Board Computer - Bosch Nyon Operating Instructions Manual

English – 18

Power Supply of External Devices via USB Connection

With the USB connection, it is possible to operate and charge most devices
whose power supply is possible via USB (e. g., various mobile phones).
Prerequisite for charging is that the on-board computer and a sufficiently
charged battery pack are inserted in the eBike.
Open the protective cap 9 of the USB port on the on-board computer. Con-
nect the USB connection of the external device to the USB port 8 on the on-
board computer using the USB charging cable Micro A – Micro B (available
from your Bosch eBike dealer).
Once the consumer has been disconnected, the USB connection must be
sealed again carefully with the protective cap 9.
 USB connections are not a waterproof. When cycling in the rain, do
not connect any external devices and make sure that the USB port
is fully covered by the protective cap 9.
Attention: Users connected to Nyon can affect the range of the eBike.

Initial Operation of the On-board Computer

The battery pack is supplied partially charged. Before the first use, the
Nyon battery pack must be fully charged via the USB port (see "Energy sup-
ply of the on-board computer", page English – 32) or the eBike system.
In order to use all the features of the operating system, you must also
register online.
1 270 020 Wen | (13.5.16) Bosch eBike Systems