Table of Contents
Advertisement
PROBLEM
OVEN LIGHT DOES
NOT COME ON
OVEN WILL NOT
SELF-CLEAN
DOOR WON'T OPEN AFTER
SELF-CLEAN CYCLE
OVEN TEMPERATURE
TOO HOT OR TOO COLD
"BURNING" OR "OILY"
ODOR EMITTING FROM
OVEN WHEN TURNED ON
STRONG ODOR
VENT SYSTEM BLOWER
DOES NOT WORK
GE Answer Center@
800.626.2000
consumer information service
50
PROBLEM SOLVER
(continued)
POSSIBLE CAUSE
Bulb may be loose or burned out, especially if the oven controlklock is working.
STOP TIME must be 3]% hours later than START TIME.
cool to room temperature and reset the controls.
If the self-cleaning mode malfunctions, turn off and disconnect power supply.
Have the range serviced by a qualified technician.
When the temperature has fallen below the locking temperature the door
can be opened.
Thermostat-Do
This is normal in a new oven and will disappear in time. To speed the process,
set a self-clean cycle for a minimum of 3 hours. See the Operating the
Self-Cleaning Oven section.
An odor from the insulation around the inside of the oven is normal for the
first few times the oven is used. This is temporary.
The circuit breaker in your house has been tripped, or a fuse has been blown.
If the modules operate but the blower doesn't, the fault may be in the blower
control switch or blower wiring connections. Be sure to disconnect power to
the range at the household distribution panel before attempting to service the
blower-yourself.
Advertisement
Table of Contents
