Advertisement

Quick Links

Installation
Instructions
Questions? Call 1-800-361-3400 or Visit our Website at: www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these
instructions for future reference.
• Skill level – Installation of this appliance
requires basic mechanical skills.
• Product failure due to improper installation
is not covered under the Warranty.
WARNING
be properly connected by means of the
supplied cord and plug. If your kitchen does
not have a receptacle, you must have one
installed by a licensed electrician.
FOR YOUR SAFETY:
CAUTION:
remove house fuse or open circuit breaker
before beginning installation. Failure to do so
could result in serious injury or even death.
TOOLS YOU WILL NEED
"
Drill with 1/8
Bit
Straight Edge
Hand or Saber Saw
4053P595
229C
31-10597
09-04 JR
— Observe all
— This appliance must
— For Personal Safety
Safety Glasses
Tape Measure
Pencil
30" Electric
Slide-In Range
JCSP38
ANTI-TIP DEVICE
WARNING
of tipping, the appliance must be secured by
properly installed Anti-Tip bracket packed
with this appliance.
If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB2X7909.
If you pull the range out and away from the
wall for any reason, make sure the Anti-Tip
bracket is engaged when the range is pushed
back against the wall.
FOR YOUR SAFETY:
All rough-in and spacing dimensions must be
met for safe use of your range. Electricity to
the range can be disconnected at the outlet
without moving the range if the outlet is in
the preferred location (remove lower drawer).
To reduce the risk of burns or fire when
reaching over hot surface elements, cabinet
storage space above the cooktop should be
avoided. If cabinet storage space is to be
provided above the cooktop, the risk can
be reduced by installing a range hood that
sticks out at least 5" beyond the front of the
cabinets. Cabinets installed above a cooktop
must be no deeper than 13".
1 1
— To reduce the risk
WARNING
• All ranges can tip
• Injury to persons could result
• Install Anti-Tip bracket packed
with range
• See Installation Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JCSP38 and is the answer not in the manual?

Questions and answers

Summary of Contents for GEAppliances JCSP38

  • Page 1 Installation 30” Electric Instructions Slide-In Range JCSP38 Questions? Call 1-800-361-3400 or Visit our Website at: www.GEAppliances.ca BEFORE YOU BEGIN ANTI-TIP DEVICE Read these instructions completely WARNING — To reduce the risk and carefully. of tipping, the appliance must be secured by...
  • Page 2: Prepare To Install The Range

    Installation Instructions PREPARE TO INSTALL THE RANGE • Move range indoors in front of cabinet DOOR REMOVAL (optional) opening. • Protect the kitchen floor! Flatten and place a Door removal is not a requirement for piece of the shipping carton in front of the installation of the product, but is an added installation location to protect the flooring.
  • Page 3: Minimum Clearances

    Installation Instructions MINIMUM CLEARANCES Make sure the wall coverings, countertop and • The distance from the floor to the top cabinets around the cooktop can withstand the of the counter must be at least 35-7/8″. heat (up to 200°F) generated by the range. The maximum counter height is 38″.
  • Page 4: Preparing The Counter

    Installation Instructions PREPARE TO INSTALL THE RANGE (CONT.) PREPARATION PREPARING THE COUNTER (CONT.) • Remove all tape and packaging. Be sure to remove clear plastic film that covers some chrome parts (around glass oven doors, Screw side trim) and any tape and packaging from Filler Strip inside the oven.
  • Page 5: Side Trim Extension Kit

    Installation Instructions PREPARE THE COUNTER SIDE TRIM EXTENSION KIT (CONT.) If you are using the Filler or Backguard: If there is a small gap between the sides of the range and the cabinets (up to 1/4″ each side), you can order a side trim extension kit, JXS86XX, through the National Parts Center.
  • Page 6: Install The Range

    Installation Instructions INSTALL THE RANGE ANTI-TIP DEVICE INSTALLATION SLIDE RANGE INTO OPENING An Anti-Tip bracket is supplied with Plug the power cord into the receptacle. instructions for installation in a variety of Locate the cord in the back of the range locations.
  • Page 7: Replacing The Oven Door

    Installation Instructions REPLACING THE OVEN DOOR REPLACING THE STORAGE DRAWER NOTE: The oven door is heavy. You may need help lifting the door high enough to slide it Place the drawer into the hinge slots. Do not lift the door by rail on the the handle.
  • Page 8: Final Installation Checklist

    Installation Instructions IMPORTANT INSTALLATION FINAL INSTALLATION CHECKLIST INSTRUCTIONS FOR RANGES USED WITH COUNTERTOP • Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced. HEIGHTS UP TO 38″ • Be sure power is in service to the building. The height of the range must be adjusted to the •...

Table of Contents