Table of Contents
Advertisement
Your non-stick coated griddle provides an extra-large cooking surface
for meats, pancakes or other foods usually prepared in a frying pan or
electric skillet. You can also use the griddle as a warming tray by using
a low-heat setting.
How to Assemble the Griddle Accessory
1. Be
the controls are OFF.
sure
2. Place the two reflector plates in the grease well.
3.
the grill element with both hands near the
plug. Keeping the element as nearly horizontal us
possible, push the plug firmly into the receptacle
to inslu-e complete contact.
4. Place the griddle into the opening in the cooktop
with the two drain holes toward the front of the
illustration.
NOTE: When properly placed, the griddle sits
slightly above the cooktop. This, and the open
spaces on the sides and rear of the griddle, prevent
excessive temperatures.
Using the Griddle
The non-stick griddle must be preconditioned
before using it for the first time. To precondition.
use a paper towel to apply a small amount of cooking
paper towel.
Preheat [he griddle as recommended in the Griddle
Cooking Guide. After preheating fur the recommended
How to Remove the Griddle Accessory
Be sure the controls are OFF and the griddle
is cool.
To remove the griddle:
1. Lift the back edge of the griddle a bit to let any
excess fat or oil drain.
2. Remove the griddle.
22
GRIDDLE ACCESSORY
Do not overheat the griddle. Leaving the griddle
at HI for more than 10 minutes without food can
damage the non-stick coating.
When using the griddle, the blower system is
automatically controlled.
Always turn on both sections of the heating element
under the griddle. Heating cmiy part of dlc griddle
may warp it and wi II result in non-uniform cooking.
Because the heating element under the griddle is
divided, you can vary the temperature on the front and
rear sections.
3. Grasp the element with both hands on either side
of the plug.
4. Raise the opposite side of the element just enough
to clear the well, then pull away from the receptacle.
The element will not sit level when replaced if it is
forced too far upward when relnoved.
5. Remove the two reflector plates.
Advertisement
Table of Contents
