Connections; Cartridge Installation; Removing The Compactflash™; Installing The Compactflash™ - Geonav 6 Sunshine User And Installation Manual

Connections

CONNECTIONS
Power supply and data cable
1. Power supply
red wire +VDC
black wire GND
2. Data input ext. GPS
brown wire ext. GPS in +
yellow wire ext. GPS in -
3. Data output
violet wire Autopilot out + pin 5
white wire Autopilot out - pin 6
4. Data input depth sounder
blue wire DS in +
green wire DS in -
SHIELD
If sent by the autopilot, the following NMEA messages are
transmitted to external devices: GGA - RMC - ZDA
The GEONAV will add the following messages: APA - APB -
XTE - RMB - BWC - GLL - VTG
The data cable is supplied together with the GEONAV plotter.
WARNING: Once the installation is completed, always make sure that all wires are
properly connected since wrong connections may damage the unit.
English
10
pin 1
pin 2
pin 3
pin 4
pin 7
pin 8
pin 9

Cartridge Installation

CARTRIDGE INSTALLATION
Installing the CompactFlash™
Remove the rubber cap from the cartridge slot located in the
right-hand side of the plotter.
Insert the cartridge into the appropriate slot, with the label
side (side with a small arrow) backwards and push it.
Replace the cap exercising firm pressure and check that it is
perfectly closed, in order to avoid any water infiltration.
NOTE: Make sure of inserting the cartridge correctly. Should you try to insert the
wrong side of the cartridge, full insertion into the slot is hampered. Any further attempt
to force the cartridge into the slot may damage the cartridge or the plotter. This kind of
damage is not covered by the warranty.
Removing the CompactFlash™
Make sure that the plotter is perfectly dry.
Remove the rubber cap from the cartridge slot located in the
right-hand side of the plotter, then extract the cartridge.
11
English