Bosch SHE66C Use And Care Manual page 14

Hide thumbs Also See for SHE66C:
Table of Contents

Advertisement

Available languages

Available languages

Operating the Dishwasher
Interrupting a Cycle
NOTE: Should you need to interrupt a cycle (to
add or remove an item, to add detergent, etc.), it
cycle.
Open the dishwasher door far enough to expose
the control buttons.
Press the On/Off button.
WARNING
You could be seriously scalded if you allow
hot water to splash out of the dishwasher.
OPEN THE DOOR CAREFULLY during any
wash or rinse cycle. Do not fully open the
door until water noises have stopped.
Wait at least ten seconds or until water noises
stop before opening the dishwasher door.
To resume the cycle, press the On/Off button and
shut the dishwasher door.
Canceling or Changing a Cycle
To cancel or change a cycle, open the
dishwasher door far enough to expose the control
buttons then press and hold for three seconds the
two buttons labeled "Cancel Drain" as shown in
Figure 27.
Figure 27
Close the door and wait until the dishwasher
completes the cycle (approximately 1 minute).
Open the door and press the ON/OFF button.
You may now begin a new cycle.
Child Safety Latch
Your dishwasher is shipped from the factory with
the Child Safety Latch disengaged and in the
normal operating mode. Pull on the door handle
to open the door. The Child Safety latch activation
12
lever is located in the recess for the door handle.
Safety Latch activation lever (see Figure 28).
To activate the Child Safety Latch insert a
matchstick or other non-metal object into the
opening as shown in Figure 28. The activation
lever will release and move toward the left.
You have now activated the Child Safety Latch.
Each time you open the dishwasher door you will
need to slide the activation lever to the right
to release the door locking mechanism, you can
then pull the door open (See Figure 29). After
you open the door you should release the Child
Safety Latch Activation lever and let it slide back
toward the left.
To deactivate the Child Safety Latch insert a
matchstick or other non-metal object into the
opening as shown in Figure 30. Slide the
activation lever to the right and hold. Remove the
matchstick and release the lever. The feature has
now been deactivated and you can open the door
by pulling the handle.
Figure 28
Figure 30
Figure 29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Shv56cShx57cShv57cShy56aShe58cShx56c

Table of Contents