Technical Data; Installation - Zanussi zfu19400wa User Manual

Problem
Green indicator flashing
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance should be installed in a dry,
well ventilated indoor where the ambient tem-
perature corresponds to the climate class indi-
cated on the rating plate of the appliance:
www.zanussi.com
Possible cause
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
The appliance is not switched on
Temperature Regulator is not on
Temperature sensor problem
Height
Width
Depth
Call an electrician
Switch on the appliance
Check the Temperature Regulator
Call the service personnel
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1250 mm
545 mm
640 mm
18 h
230 V
50 Hz
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur for
some types of models when operating outside
of that range. The correct operation can only
be guaranteed within the specified tempera-
ture range. If you have any doubts regarding
where to install the appliance, please turn to
Solution
23