Zanussi zfu19400wa User Manual page 24

the vendor, to our customer service or to the
nearest Service Centre
Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted as shown in
the figure.
1. Fit the spacers
into the holes.
Make sure that
the arrow (A) is
positioned as
shown in the
picture.
2. Turn counter-
clockwise the
spacers through
45° until they
lock into place.
Levelling
When placing the
appliance ensure that
it stands level. This
can be achieved by
two adjustable feet at
the bottom in front
(2). If necessary ad-
just the feet by re-
moving the spacer
(1).
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circu-
late freely around the back of the cabinet. To
24
A
45˚
1
2
ensure best performance, if the appliance is
positioned below an overhanging wall unit, the
minimum distance between the top of the cab-
inet and the wall unit must be at least 100
mm . Ideally, however, the appliance should
not be positioned below overhanging wall
units. Accurate levelling is ensured by one or
more adjustable feet at the base of the cabi-
net.
If the cabinet is placed in a corner and the
side with the hinges facing the wall, the dis-
tance between the wall and the cabinet must
be at least 10 mm to allow the door to open
enough so that the shelves can be removed.
Warning!
min.
100 mm
15 mm 15 mm
It must be possible to disconnect the
appliance from the mains power supply; the
plug must therefore be easily accessible after
installation.
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on
the doors of the appliance during the
operations.
To change the opening direction of the door,
do these steps:
www.zanussi.com