Routing - D-Link DWR-161 User Manual

Section 3 - Configuration
The Routing page allows you to specify custom routes that determine how data is moved around your network.
RIP:
ID:
Destination:
Subnet Mask:
Gateway:
Hop:
Enable:
D-Link DWR-161 User Manual
RIP SETTING
Select this box to enable routing.
RIPv1: Protocol in which the IP address
is routed through the Internet.
RIPv2: Enhanced version of RIPv1 with
added features such as Authentication,
Routing Domain, Next Hop Forwarding,
and Subnet-mask Exchange.
ROUTING RULES
Identifies the rule.
Enter the IP of the specified network that you
want to access using the static route.
Enter the subnet mask to be used for the
specified network.
Enter the gateway IP address to the specified network.
Enter the amount of hops it will take to reach the specified network.
Note: In a transmission path, each link is terminated at a network device such as a router or gateway. The
number of hops equals the number of routers or gateways that data must pass through before reaching the
destination.
Select this box to enable the rule.

Routing

37