Connect To Your Network - D-Link DWR-161 User Manual

Section 2 - Installation

Connect to Your Network

Note: Ensure that your DWR-161 4G USB Router is disconnected and powered off before performing the installation steps below.
1. Connect a USB modem to the USB port on the back of the router.
2. Insert a LAN network cable into the LAN port on the back of the router. Plug the other end of the LAN cable into the LAN port of your
computer or laptop. The Ethernet LED will turn green if the Ethernet connection is successfully established.
Note: The DWR-161 4G USB Router LAN Port is Auto-MDI/MDIX. Therefore, patch or crossover Ethernet cables can be used.
3. Configure the device using the setup utility.
D-Link DWR-161 User Manual 8