Side Burner; Shutting Off Burners; Cleaning And Care - BBQ Grillware GSF2616 Owner's Manua

1. Open lid during lighting burner. Lid must be open when burner is on.
2. Valve must be in the "off" position
3. Open cylinder valve.
4. Push in side burner valve knob fully and rotate slowly about 1/4 turn counter-clockwise until a click is heard and this will light the burner. If the burner does not light, immediately return the valve knob to
OFF, wait five minutes for the gas to clear and repeat the procedure.
5. After burner ignites, adjust valve knob to desired cooking setting.

Shutting Off Burners

:
1. Always turn the valve knob(s) clockwise to the High position, then depress and turn it to OFF.
Never force the knob without depressing it as that can damage the valve.
2. Promptly turn the gas supply OFF at the propane cylinder.
3. Close the lid of the grill.
2"
5cm
1"
2.5cm
0"
0cm
Caution: All cleaning and maintenance should be done when grill is cool and with the fuel supply turned off at the control dial and the propane cylinder disconnected. DO NOT clean any grill part in a self
cleaning oven. The extreme heat will damage the finish.
Cleaning
Burning-off the grill after every use (approx. 15 minutes) will keep excessive food residue from building up.
Recommended cleaning materials -
Mild dishwashing liquid detergent
Nylon cleaning pad
Paper clip
Compressed air
DO NOT use cleaners that contain acid, mineral spirits or xylene.
Outside surfaces -
Use a mild dishwashing detergent and hot water solution to clean, then rinse with water.
If the inside surface of the grill lid has the appearance of peeling paint, baked on grease buildup has turned to carbon and is flaking off. Clean thoroughly with strong solution of detergent and hot water.
Rinse with water and allow to completely dry.
Interior of grill bottom – Remove residue using brush, scraper and/or cleaning pad, then wash with dishwashing detergent and hot water solution. Rinse with water and let thoroughly dry.
Cooking Grids – The porcelain grates have a glass-like composition that should be handled with care not to chip. Use mild dishwashing detergent or baking soda and hot water solution. Non abrasive
scouring powder can be used on stubborn stains, then rinse with water.
Heat Plates – Clean residue with wire brush and wash with soapy water, then rinse with water.
GSF2616 owner's manual

Side Burner

Observe Flame Height When lit:
Flame should be a Blue / Yellow color Between1"– 2" High

Cleaning and Care

Hot water
Wire brush
Putty knife/scraper
24