Table of Contents
Advertisement
DANGER
Never store a spare propane cylinder under or near this grill.
A fire causing death or serious injury may occur if the above is not followed exactly.
Check for leaks. Make sure the regulator valve is securely fastened to the burner and the cylinder.
Make 2-3 oz. (0-90ml) of leak solution by mixing one part liquid dishwashing soap with three parts water.
Make sure control knobs are off.
Spoon several drops of solution at the tank valve to regulator connection.
Inspect the solution at the connection, looking for bubbles. If NO bubbles appear, the connection is secure.
If bubbles appear, you have a leak, recheck as :
Disconnect regulator from tank and reconnect, making sure the connection is secure.
Retest with solution. If you continue to see bubbles, replace the cylinder.
Danger: Failure to open lid while igniting the barbecue's burners or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame-up which can
cause serious bodily injury or death.
1.
Open lid during lighting burners.
Attempting to light the burner with the lid closed may cause an explosion! Make sure there are no obstructions of airflow to the gas unit. Spiders and insects can nest within and clog the burner/venturi
tube at the orifice.
A clogged burner tube can lead to a fire beneath the appliance.
2.
All valves must be in the OFF position.
3.
Open cylinder valve.
4.
Ignite only the burners you desire to use, using the same method for each:
Push in desired burner valve knob fully and rotate slowly about 1/4 turn counter-clockwise
until a click is heard and this will light the burner. If the burner does not light, immediately return
the valve knob to OFF, wait five minutes for the gas to clear and repeat the procedure.
After burner ignites, repeat the same procedure with any other burner desired.
5.
Adjust valve knob(s) to desired cooking setting.
Lighting Rod Light the Main Burners:
1.
Remove cooking grid from burner you desired to light.
2.
Dip the end of lighting rod into flamable liquid as kerosene then light it. Once lit, place the flame through the hole as shown near the burner ports.
3.
Press in valve knob and rotate counter clockwise to Hi setting and burner should light immediately. If more than one burner is desired, repeat procedure with each burner.
4.
Replace cooking grid and adjust burners to desired cooking settings.
Option-Left and right main burners can be lit by inserting a lit match attached to the end of the Lighting Rod through holes on either side as desired.
After lighting, please observe the burner flame, make sure all burner ports are lighted.
If burner flame goes out during operation, immediately turn the gas "off" and open lid to let the gas clear for about 5 minutes before re-lighting.
Before cooking on this grill for the first time, operate the grill for about 15 minutes with the lid closed and the gas turned on "high." This will "heat clean" the internal parts and dissipate odor from the
manufacturing processes and painted finish.
Clean your grill after each use, DO NOT use abrasive or flammable cleaners, as it will damage the parts of this product and may start a fire.
GSF2616 owner's manual
TO CHECK FOR LEAKS:
Lighting Your Grill
Main Burner
23
Hide quick links:
Advertisement
Table of Contents
