Cycle phase indicators
When a wash or disinfection cycle has
been selected, the phase indicator
lights on the control panel will show the
cycle sequence.
When phase of the cycle is completed,
the corresponding indicator light goes
out. The wash cycle is completed when
the START light goes out.
Selecting an additional cycle
The following additional cycles are
available:
DRYING
NOTE: The heat retention capacity of
stainless steel allows for fast drying.
Plastic has a lower heat retention ca-
pacity, thus needing a longer drying
time.
CAUTION: If instruments have to be
dry for further instrument process-
ing, the drying option of G 7782 may
not be sufficient. In these cases use
G 7782 CD with a forced air drying
unit (TA).
Washer/Disinfector operation
This cycle may be selected immediate-
ly after choosing a processing cycle
(exception: RINSE cycle) by pushing
the DRYING touch pad.
REACTIVATION
See "Reactivating the water softener"
NOTE: To prevent corrosion, the drying
cycle should be set to a time and tem-
perature that ensure thorough drying
after the wash and disinfection cycle.
DRAIN
1. Press the ON/OFF button.
2. Press the DRAIN touch pad.
3. Press the START touch pad.
37