Lexus rx350 2016 Owner's Manual page 145

NOTICE
Close & lock function
■
When closing the power back door using the close & lock function, a different buzzer
than the normal one will sound before the operation begins.
To check that the operation has started correctly, check that a different buzzer than the
normal one has sounded.
Additionally, when the power back door is fully closed and locked, operation signals
will indicate that all of the doors have been locked.
Before leaving the vehicle, make sure that the operational signals have operated and
that all of the doors are locked.
Touchless sensor precautions (vehicles with a touchless power back door)
■
The touchless sensor is located behind the rear emblem. Observe the following to
ensure that the touchless power back door function operates properly:
Operate the touchless sensor while carrying an electronic key within the operational
●
range.
Keep the rear emblem clean at all times.
●
If the rear emblem is dirty or covered with snow, the touchless sensor may not oper-
ate. In this situation, clean off the dirt or snow, move the vehicle from the current posi-
tion and then check if the touchless sensor operates. If it does not operate, have the
vehicle inspected by your Lexus dealer.
Do not apply coatings that have a rain clearing (hydrophilic) effect, or other coatings,
●
to the rear emblem.
Do not park the vehicle near objects that may move and contact the rear emblem,
●
such as tall grass or trees.
If the vehicle has been parked for a while near objects that may move and contact the
rear emblem, such as tall grass or trees, the touchless sensor may not operate. In this
situation, move the vehicle from the current position and then check if the touchless
sensor operates. If it does not operate, have the vehicle inspected by your Lexus
dealer.
Do not subject the touchless sensor or its surrounding area to a strong impact.
●
If the touchless sensor or its surrounding area has been subjected to a strong impact,
the touchless sensor may not operate properly.
If the touchless sensor does not operate in the following situations, have the vehicle
inspected by your Lexus dealer.
• The touchless sensor or its surrounding area has been subjected to a strong
impact.
• The rear emblem is scratched or damaged.
Do not disassemble the rear emblem.
●
Do not attach stickers to the rear emblem.
●
Do not paint the rear emblem.
●
If a bicycle carrier or similar heavy object is attached to the power back door, disable
●
the touchless sensor. (P. 100)
To prevent unintentional operation (vehicles with a touchless power back door)
■
When the touchless sensor is not to be used, disable the touchless sensor operation
using the multi-information display (P. 100)
RX350_U_OM48E90U
3-2. Opening, closing and locking the doors
145
3