Asia And General Models Only - Yamaha RX-V3800 Owner's Manual

Advanced setup
Press and hold M LEARN for about 3
2
seconds using a ballpoint pen or similar
object until "L;TUN" and "TUNER"
alternately appear in the display window (B).
3 seconds
Notes
• Be sure to press and hold M LEARN for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 2.
Press 4 ENTER.
3
The four-digit code set for the selected input area
appears in the display window (B) on the remote
control.
4
Press the numeric buttons ( 6 ) to enter the
four-digit remote control code for the input
area you want to use.
Remote
control
Function
TUNER ID
*1
code
2602 Operates this unit using the
(initial setting) default code.
Operates this unit using an
2603
alternative code.
*1 The remote control setting.
*2 The setting of this unit.
Press 4 ENTER to set the number.
5
"OK" appears in the display window (B) if the
setting was successful.
"NG" appears in the display window (B) if the
setting was unsuccessful. In this case, start over from
step 2.
Press M LEARN again to exit from the setup
6
mode.
122
En
LEARN
RC TUNER
*2
ID
ID1
(initial setting)
ID2
LEARN
See page 120 for the operation of the advanced setup.
Tuner frequency step

(Asia and General models only)

Use this feature to set the tuner frequency step according
to the frequency spacing in your area.
Choices: AM10/FM100, AM9/FM50
• Select "AM10/FM100" for North, Central and South
America.
• Select "AM9/FM50" for all other areas.
Bi-amplifier setting
Use this feature to activate or deactivate the bi-amplifier
function.
Choices: ON, OFF
• Select "ON" if you want to activate the bi-amplifier
function.
• Select "OFF" if you want to deactivate the bi-amplifier
function.
Note
When "BI-AMP" is set to "ON", the SURROUND BACK
terminals cannot be used to connect surround back speakers in
that the SURROUND BACK terminals are already used for the
bi-amplifier connection (see page 19).
TUNER FRQ STEP
BI-AMP