Yamaha RX-V3800 Firmware Update Procedure

7.1-channel digital home theater receiver

Hide thumbs Also See for RX-V3800:

Download this manual See also: Service Manual, Owner's Manual

March, 2009

Subject: RX-V3800 Firmware Update V:O061

Yamaha is pleased to offer the following firmware to ensure the best possible

performance for your Yamaha RX-V3800 AV Receiver.

improves the video section to ensure RGB full range repeat through HDMI

connection.

Requirements:

The following pages contain the firmware update instructions for the RX-V3800.

The outline of the update procedure is as follows:

1. Copy the firmware file to the USB flash drive

2. Enter USB firmware update mode in the advanced setup

3. Insert USB flash drive to AV receiver

4. Confirm updated firmware version

Note: Executing this update will RESET the receiver's setting to factory default.

< IMPORTANT NOTICE >

Do not attempt to update your Yamaha receiver using any other data file except those provided

directly from the Yamaha website.

Follow the instructions carefully and do not attempt any other procedures not specified in the

instructions provided by Yamaha.

Improperly updated products may cause improper operation, and any parts or service required

to restore proper operation will not be covered under the Yamaha Limited Warranty.

Firmware Update Procedure for RX-V3800

A personal computer

USB flash drive (Supporting Mass Storage Class)

Page.1 of 4

This firmware

Page 1 Note: Executing this update will RESET the receiver’s setting to factory default. < IMPORTANT NOTICE > Do not attempt to update your Yamaha receiver using any other data file except those provided directly from the Yamaha website. Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by Yamaha.
Page 2 SLEEP PROGRAM Step 2. Confirm that the AC power cable of the Yamaha receiver is plugged to the wall outlet and [MASTER] button is switched to the OFF position. Step 3. Press and hold the [STRAIGHT] button behind the front lid and keep it pressed.
Page 3 Firmware Update Procedure for RX-V3800 Step 7. After “Firmware Update is complete” is displayed for few seconds, the receiver will power OFF and ON by itself. Step 8. Turn off the power of the receiver by pressing the [MASTER] button.
Page 4 1 to 12 all over again. If AC power was lost unintentionally during the update process, please follow recovery steps mentioned below to get the RX-V3800 into USB memory firmware upgrade mode again.