Yamaha RX-V3800 Owner's Manual page 120

Using multi-zone configuration
Operate the following operations after activating the Zone 2
or Zone 3 operation mode.
Adjusting the volume level of Zone 2 or
Zone 3
Rotate RVOLUME on the front panel (or press
CVOLUME +/–) to adjust the volume level of the
selected zone.
y
Press E MUTE on the remote control to mute the sound output to
the selected zone.
Note
When you use the external amplifiers in Zone 2 or Zone 3,
C VOLUME +/– can be used only when "Zone2 Volume" or
"Zone3 Volume" is set to "Variable" in "Zone2 Set" or "Zone3
Set" (see page 94).
Adjusting the balance of the speaker
level in Zone 2 or Zone 3
Press E TONE CONTROL repeatedly to select
"BALANCE" and then rotate OPROGRAM to
adjust the balance of the front left and right
speaker level of the selected zone.
118
En
Adjusting the tonal quality of Zone 2 or
Zone 3
Set the operation mode selector to D AMP and
then press CH +/– on the remote control to
adjust the high-frequency response (TREBLE) or
TV VOL +/– to adjust the low-frequency
response (BASS) respectively.
TV VOL
AMP
SOURCE
TV
y
You can also adjust the tonal quality of Zone 2 or Zone 3 by using
E TONE CONTROL on the front panel. For details, see
"Adjusting the tonal quality" on page 51.
Note
Check that "ZONE 2" or "ZONE 3" is displayed in the display
window (B) of the remote control before you adjust the tonal
quality of the corresponding zone (see page 117).
+
BASS
–
+
TREBLE
CH
–